Here is my long term project. Originally a
San Diego, California car, that I begged and pleaded to buy from the
original family that bought the car new. As I found it, it had a spun
rod bearing, and had been sitting in the weeds for about ten years. In
the last eight years that I have had it, I had the original 361 rebuilt
by Ed Hale, in Lakeside, Ca, and just went through the original 4 spd,
replacing the clutch and pressure plate.
When I started working on the car it
had a white vinyl top, that was about wore off, so I just finished
peeling it, and buffed the paint. The body is 100% original, all dents,
and VERY small amount of rust shows on the rear quarters. It will get
done some day?? Fun to drive and show off, even though its no show car..
Thanks for posting, Nick
Nick Kruczkowski
Vacherie, Louisiana
Related Chrysler,
Dodge, Plymouth and Mopar Stuff:
Search The Mopars
Of The Month Site:
We are always
looking for Mopars to add to 440'S Mopars Of The Month. To
participate you must own a Mopar of some kind. (Dodge, Chrysler,
Plymouth, Desoto, Amc, Jeep, Dodge Truck, etc.) It can be your daily
driver or your mopar race car or maybe your mopar show car it does
not matter WE WILL POST IT !
The Mopars Of The Month
Site
is an independently operated Mopar Enthusiast Internet site. Built for
Mopar Enthusiasts by Mopar Enthusiasts. Our
site and network of Mopar related sites are not affiliated with or
directly sponsored by Chrysler
Group LLC. Dodge, Chrysler, Jeep, Plymouth and Mopar are all trademarks of
Chrysler Group LLC and are used only for descriptive
purposes.
